MAINTENANCE STAND
Use two people to place
the motorcycle on the maintenance stand.
WARNING
Improper use of the maintenance stand may cause
injury.
- Be sure the maintenance stand is placed on a firm, level ground.
- Never ride the motorcycle on the maintenance stand or run the engine while the motorcycle is on the maintenance stand.
- Be sure the maintenance stand is fully engaged and the attaching bolt is fastened securely before working on the motorcycle.
To install :
1. Support the motorcycle on
a firm, level ground using the side stand.
2. Install the maintenance
stand on the motorcycle as follows:
- Align the top ends of the maintenance stand (1) with the rear axle nut (2).
- Turn the attaching bolt (3) in until resistance is felt.
3. Raising the motorcycle
onto the stand as follows:
- While holding the handlebars, support the motorcycle upright and retract the side stand.
- Have an assistant check that the attaching bolt is tightened securely and is aligned with the rear axle nut properly. If necessary, reinstall the maintenance stand.
- Have the assistant rest his right foot on the maintenance stand and his hands on the rear of the rear cowl.
- Pull the motorcycle backward while simultaneously, letting the assistant shift his weight onto the maintenance stand.
CAUTION:
Do not pull up on the rear cowl during this
operation.
To remove:
1. Retract the side stand.
2. Hold the handlebars and
push the motorcycle forward.
3. Lower the side stand and
support the motorcycle on it.
4. Remove the maintenance
stand.
No comments:
Post a Comment