NSR 150 SP Owner's Manual: Bulb Replacement

BULB REPLACEMENT

(Refer to the maintenance precaution)

AWARNING

The light bulb becomes very hot while the light is ON, and remain hot for a while after it is turned OFF. Be sure to let it cool down before servicing.

CAUTION:

• Do not put finger prints on the headlight bulb, as they may create hot spots on the bulb and cause it to break.
• Wear clean gloves while replacing the bulb.
• If you touch the bulb with your bare hands, clean it with a cloth moistened with alcohol to prevent its early failure.

NOTE:

1. Be sure to turn the ignition switch OFF when replacing the bulb.
2. Do not use bulbs other than that specified.
3. After installing a new bulb, check that the light operates properly.

Headlight Bulb

1.    Pull back the rubber cover (1).

2.    Slightly press the socket (2) and turn it counterclockwise, then remove the socket.

3.    Pullout the bulb (3).

4.    Install a new bulb in the reverse order of removal.

Front/Rear Turn Signal Bulb

1.    Remove the turn signal lens (1) by removing screw (2).

2.    Pull out the turn signal bulb (3).

3.    Install a new bulb in the reverse order of removal.

Stoprrail Light Bulb

1.    Remove the right side cover.

2.    Remove the tail cover (1) by removing screws (2).

3.    Remove the taillight lens (3) by removing screw (4).

4.    Slightly press the bulb (5) and turn it counterclockwise.

5.    Install a new bulb in the reverse order of removal.