NSR 150 SP Owner's Manual: Starting the Engine

STARTING THE ENGINE

Always follow the proper starting procedure described below.

WARNING

• Never run the engine in an enclosed area. The exhaust contains poisonous carbon monoxide gas that can cause loss of consciousness and lead to death.
• Do not try to start the motorcycle with the transmission in gear. You may injure yourself or damage the motorcycle.

Preparation

Before starting, insert the key, turn the ignition switch ON and confirm the

following;

• The Transmission is in NEUTRAL (neutral indicator ON).
• The engine stop switch is at RUN.
• The fuel cock is ON.

Starting Procedure

Cold engine:

1.    Pull the choke knob (1) up all the way to Fully ON (A).

2.    With the throttle closed, operate the kick starter with the right foot, starting from the top of the stroke and following through to the bottom with a rapid and continuous motion. (If you cannot start the engine; follow the "Warm engine" starting procedure.)

CAUTION:

• Do not operate the kickstarter pedal white the engine is running as engine damage could result. Do not apply excessive force on the starter pedal.
• Fold up the kickstarter pedal after the kickstarter is returned to the pedal stop.

3.    Warm up the engine until it runs smoothly with the choke knob Fully OFF (8).

Warm engine:

1. Do not use the choke.

2. Open the throttle 1/8 - 1/4 turn.

3. Operate the kickstarter.

Flooded Engine

If the engine fails to start after several repeated attempts, it may have become flooded with excess fuel. To clear the engine, turn the engine stop switch OFF and push the choke knob to Fully OFF (8). Open the throttle fully and crank the engine several times with the kickstarter. Turn the engine stop switch to RUN and open the throttle slightly; start the engine.